1. 1. Kihara, H., and Masubuchi, K., “Studies on the shrinkage and residual welding stress of constrained fundamental joint”, Report No. 24, Transportation Technical Research Institute, No. 7, 1956.
   2. Hirai, S., and Nakamura, I., “Research on angular change in fillet welds”, Ishikawajima Review, 1955, pp 59–68.
   3. Kumose, T., Yoshida, T., Abe, T., and Onoue, H., “Prediction of angular distortion caused by one pass fillet welding”, Welding Journal 33, 1954, pp 945–956.
   4.  Mahendramani, G., and Lakshmana Swamy, N., “Effect of groove angle in butt-joints on angular distortion in submerged arc welding”, Indian Welding Journal, Vol.46 (3), July 2013, pp. 33– 37.
   5. Mahendramani, G., and Lakshmana Swamy, N., “Effect of throat thickness on angular distortion of butt welded joints in submerged arc welding”, International Journal of Materials Science, Vol.9 (1), 2014, pp. 19–25.
   6. Watanabe, M., and Satoh, K., “Effect of welding conditions on the shrinkage and distortion in welded structures”, Welding Journal 40(8), 1961, pp 377s-384s.
   7. Mandal, A., and Parmar, R. S., “Effect of process variables and angular distortion of pulse GMAW welded HSLA plates”, Indian Welding Journal, 1997, pp 26–34.
   8. Vel Murugan, V., and Gunaraj, V., “Effects of process parameters on angular distortion of gas metal arc welded structural steel plates”, Welding Journal 84(11), 2005, pp 165s-171s.
   9. Yuan, M. G., and Ueda, Y., “Prediction of residual stresses in welded T and I-joints using inherent strains”, Journal of Engineering Materials and Technology 118(4), 1996, pp 229–2.