1. 1. [1] C. Ezilarasan a, V.S. Senthil kumar, A. Velayudham,” An experimental analysis and measurement of process performances in machining of nimonic C-263 super alloy”, Measurement 46 (2013) 185–199
   2. Koyilada, S. Gangopadhyay, A. Thakur” Comparative evaluation of machinability characteristics of Nimonic C-263 using CVD and PVD coated tools”, Measurement 85 (2016) 152–163
   3. Shuho Koseki, Kenichi Inoue, Shigekazu Morito, Takuya Ohba, Hiroshi Usuki ”Comparison of TiNcoated tools using CVD and PVD processes during continuous cutting of Ni-based”, Surface & Coatings Technology 283 (2015) 353–363.
   4. Shuangqun Zhao, Xishan Xie , Gaylord D. Smith, Shailesh J. Patel “Microstructural stability and mechanical properties of a new nickel based super alloy Isothermal high temperature low cycle fatigue behaviour of Nimonic-263 Influence of typeI and typeII hot corrosion, Materials Science and Engineering A355 (2003) 96_/105
   5.  P. Mastanaiaha, G. Madhusudhan Reddy, K. Satya Prasad, C.V.S. Murthy “An investigation on microstructures and mechanical properties of explosive cladded C103 niobium alloy over C263 nimonic alloy”, Journal of Materials Processing Technology 214 (2014) 2316–2324
   6.  P Subhash, Chandra Bose & C S P Rao, “Evaluation of Optimum Cutting Parameters In Turning of NIMONIC 75 using RSM”, International Journal on Theoretical and Applied Research in Mechanical Engineering (IJTARME), ISSN: 2319 – 3182, Volume-2, Issue-2, 2013.